Features
High torque 
 Travels 180° - full-lock to full-lock - to hold your gear in position
 securely. Not proportional. Perfect for mechanical retract 
 installation. 
 Water resistant 
 Ball bearingsIncludes
Servo w/Universal connector, as well as full set of horns, grommets, 
 bushings and mounting screws.Specifications
Length: 44mm (1.7") Weight: 35g (1.23 oz.) 
 Width: 23mm (0.9") Torque: 6.6 kg-cm (92 oz-in) 
 Height: 25mm (1.0") Speed: 0.5 sec/60°Comments
A retract servo is a very specialized servo. It is non-proportional, 
 going 180 degrees, "lock to lock". They are specifically made for 
 mechanical retracts to lock the gear in the up and down positions. 
 they DO NOT have any means of end point adjustment and can not be 
 adjusted by ATV on a transmitter. They are only able to go 180 
 degrees and provide full maximum available torque at the two end 
 points. This is their whole purpose and intentional design, but if 
 someone has a unique design situation where they need other than 
 180 degrees available, then they must use a proportional servo, 
 not a retract servo. They are specifically designed to withstand 
 constant holding loads in the up and down positions, unique to the 
 use of mechanical retracts. 
 Pneumatic retracts do not need a retract servo. A proportional 
 standard or mini servo is used to move the air valve back and forth
 
 For Gear set, order HRCM6343